Wire rope NDT system has many functions

Release time:

2021-08-16

Wire rope nondestructive inspection system is a flaw detection device, which is a flaw detection device for detecting wire rope damage, such as wire rope wear, corrosion, fatigue, broken wire and other damage. It is a real-time online monitoring of wire rope damage and an alarm when there is danger.

　　NDT for wire ropeThe system is a flaw detection device, which is a flaw detection device for detecting the damage of the wire rope, such as the wear, rust, fatigue, broken wire and other damage of the wire rope. It is a real-time online monitoring of the damage of the wire rope. An alarm is issued when there is danger.

Below, the small series for the wire rope NDT system function to do a detailed introduction:

1. Intelligent unattended operation mode can be realized, and online automatic measurement and control of steel wire rope can be carried out 24 hours a day.

2. Wide distance detection can be realized. The detection distance between the detection sensor of the wire rope online monitoring system and the surface of the wire rope should reach 30mm, which can ensure the speed of the wire rope at 18 m/s. The wire rope can be automatically measured and controlled online 24 hours a day without damaging the sensor and causing damage to the hoisting winch and safety accidents.

3. It can qualitatively detect various damages such as broken wires, abrasion, corrosion, fatigue, deformation and loose strands inside and outside the wire rope on line, and quantitatively give the magnitude and specific location of each damage.

4, high detection accuracy, strong resolution, accurate test results, wire rope non-destructive detection of wire rope internal and external damage caused by the effective metal cross-sectional area loss equivalent of quantitative judgment of 0.5 percent.

5. The weight of the test body and magnet used is less than 2kg, which is only 1/6-1/20 of that of similar products in various countries. It is extremely light and dexterous to install and use.

6. The distance between the inner sleeve and the surface of the wire rope to be tested is 20-30mm, and the design mode of relative movement between the guide wheel and the wire rope to be tested is adopted. The passing capacity of the wire rope during detection is generally not affected by the blocking factors such as wire rope deformation, sludge, dirt, and warping, and is suitable for testing in various harsh working conditions.

7, according to the detected wire rope damage value, wire rope non-destructive inspection and comparison with historical data, analysis of the trend of wire rope damage, combined with the relevant national standards, assessment of the remaining bearing capacity of the wire rope, safety factor and service life.

8. It can automatically save the detection data according to the detection time, generate database, detection report, waveform chart and detection report, and can view and print the detection data and detection report at any time.

9. Graded sound and light warning can be realized in the process of automatic detection.

10. It can be interconnected with the existing local area network of the user unit to realize remote data viewing and analysis.

11, wire rope NDT has a friendly man-machine interface, clear, remote parameter setting and automatic calibration, easy to operate.

12. It can be equipped with fault self-diagnosis function to ensure reliable operation of the equipment.

　　13、Non-destructive testing of steel wire ropeThe system has the functions of waterproof and anti-icing, which can meet the normal use under special working conditions, and is not affected by factors such as experience, skills, temperature, speed, noise, water drenching, wire sticking, and oil pollution.