Technology makes production safer.
Solution to the Fault of Wire Rope Flaw Detector
Release time:
2021-07-12
1. For the case of whether to turn on or not, the first thing we have to consider is that there is no electricity. When there is no electricity, we need to find a charger to charge and then use it. If the battery is charged or not turned on, we can try to press the power button several times, but the interval should be not less than half a minute. If it still fails, we need to consider whether it is damaged and let professionals carry out inspection and maintenance.
Before, Xiaobian explained for everyoneWire rope flaw detectorThe common faults, then how to solve these faults? Below, let's learn together!
1. For the case of whether to turn on or not, the first thing we have to consider is that there is no electricity. When there is no electricity, we need to find a charger to charge and then use it. If the battery is charged or not turned on, we can try to press the power button several times, but the interval should be not less than half a minute. If it still fails, we need to consider whether it is damaged and let professionals carry out inspection and maintenance.
2. Regarding the automatic shutdown phenomenon of the wire rope flaw detector, first consider whether the electricity quantity is too low. For the sake of protection, it is automatically shut down together. Charge it first, then start the machine and try. If it cannot be opened, contact for maintenance.
3. When there is no echo display, the memory may be confused for some reason. In this case, we need to restore the factory settings, open another normal flaw detection channel after restarting the machine, and also depend on whether the probe is connected correctly or normally. If it cannot be judged, we can restore the system parameters to the factory state, and then connect the straight probe with a new probe wire, probe on a thin block with good coupling. If there is echo, it may be due to improper setting of original parameters or poor contact of probe line.
4. When using the keyboard, pay attention to the correct operation mode, and at the same time pay attention to ensuring that every key is pressed.
5. Regarding the crash, if we cannot restart the machine even if we force the power supply to shut down, we can look at the instructions of the wire rope flaw detector to find a way to solve it. If it is really not possible, we can find the manufacturer's phone for consultation!
Above isWire rope NDT detectorIn fact, we all know that even in sophisticated machinery and equipment, failures cannot be avoided. However, the occurrence of these failures will cause staff to delay their work. Therefore, it is very important to solve the failures, especially for some common failures. We must know how to deal with them so that they can be more smoothly used, the test results can be more accurate.
recommend News
Service hotline
China (Henan) Pilot Free Trade Zone Luoyang Area High-tech 288 Heluo Road, Development Zone
Wechat Number
SAF Coolest v1.3.1.1 设置面板 GAGSD-ZGYF-JXSVE-SAS
无数据提示
Sorry, the current column is being updated, please look forward to it!
You can view other columns or returnHome Page