Common Faults of Wire Rope Nondestructive Detector

Release time:

2021-07-05

Wire rope non-destructive detectors are now widely used. No matter on elevators, mines or construction cranes, etc., they will choose to use detectors to detect the use of wire ropes, so as to ensure the service life of wire ropes. The detector has good detection effect, accurate results, simple and convenient operation and easy to carry. Therefore, it is favored by everyone. However, due to some special reasons, faults cannot be avoided during use, only when a fault occurs can it be solved to ensure normal use, so today the editor of Baikete will talk to you about its common faults, let's take a look!

Common Faults of Wire Rope Nondestructive Detector

　　Wire rope nondestructive detectorAt present, it is widely used. No matter on elevators, mines or construction cranes, etc., detectors will be used to detect the use of wire ropes, so as to ensure the service life of wire ropes. The detection effect of the detector is good, the results are accurate, the operation is simple and convenient, and it is easy to carry, so it is favored by everyone, but in the process of use, due to some special reasons, failures cannot be avoided, only when a fault occurs can it be solved to ensure normal use, so today the editor of Baikete will talk to you about its common faults, let's take a look!

1, can not start

Can't boot is a phenomenon that many machines will happen, which is also one of the more common faults. Of course, if the wire rope nondestructive detector can't boot, it will affect the detection. Under normal circumstances, it can't boot because there is no electricity, or it is damaged., And caused by operational errors.

2, automatic shutdown

The phenomenon of automatic shutdown is also common in machine equipment. This may be a fault of the machine, or a protection device and protection method of the machine. However, the phenomenon of automatic shutdown is generally caused by insufficient power of the wire rope nondestructive detector or damage.

3. No echo display

Generally, this kind of situation occurs because the probe of the wire rope nondestructive detector is not correctly connected, or because the setting method of the probe is wrong, and the probe line is not normal, etc. will have an impact.

4. Failure of keyboard operation

The wire rope non-destructive detector has the keyboard to operate when it is tested. When the keyboard is locked, it cannot be pressed, and some people will mistakenly think that it is out of order. In addition, when the keyboard is pressed, people will mistakenly think that the keyboard operation is out of order. In addition, there is an incorrect operation method, not in accordance with the prompts to operate, this mode of operation is really will cause the keyboard operation failure.

5. Crash state

In addition, there is another possibility that there is a crash. The crash state is also a state in which wire rope flaw detectors are relatively easy to occur. This situation is generally caused by system disorder or machine damage.