How to solve the quality problem of steel wire rope

Release time:

2022-06-13

How to solve the quality problem encountered by steel wire rope? The staff of Luoyang Baikte Technology Development Co., Ltd. will bring you to understand!

How to solve the quality problem of steel wire rope

wire ropeHow to solve the quality problem? The staff of Luoyang Baikte Technology Development Co., Ltd. will bring you to understand!
1. wear: is a common phenomenon. The selection of the correct structure of the wire rope can ensure that wear is only a secondary factor in damage, lubrication to help reduce wear.
2. Broken wire: It is a common phenomenon at the end of the service life of the wire rope, caused by bending fatigue and wear. Partial wire breakage may indicate mechanical defects in the equipment, and correct lubrication will improve the fatigue performance of the wire rope.
3. Deformation: It is often the result of mechanical damage. If it is serious, it will greatly affect the length of the wire rope. Rust indicates lack of proper lubrication leading to corrosion. In some cases, the outer surface of the steel wire will appear obvious point-like rust marks, so that the wire will be broken.
4. internal corrosion: appear in the lubrication is insufficient or the way is not correct. The reduction of pulp often causes the observer to speculate to this point, and the judgment can only be confirmed by internal inspection of the wire rope by the caliper or the correct use of rivets.
5. Multi-layer winding: Multi-layer winding on the drum will cause serious deformation of the lower wire rope.
6. Poor winding: Mechanical damage due to excessive tilt angle or loose winding, manifested as severe extrusion, may cause sudden load during operation.
7. The diameter of the rope wheel is too small: it will cause the deformation of the wire rope and will inevitably cause premature wire breakage.
8. The rope groove is too large: the rope groove of the rope wheel exceeds the nominal diameter by more than 15%, which will cause the wire rope to lack sufficient support, causing flattening and premature wire breakage.
9. The rope groove is too small: the wire rope will be squeezed and deformed, and two obvious wear marks and corresponding broken wires will often appear.
luoyang baikert technology development co., ltd. uphold the "wire rope life cycle management" concept, to provide comprehensive solutions based on technology and equipment of wire rope safety, the mainNon-destructive testing of steel wire ropeNDT, wire rope NDT, wire rope NDT, wire rope NDT and other products and services, market services cover many areas.